100 Years

Of Experience

Leading Provider

Of Polymer Sealing Solutions

  • Facebook
  • LinkedIn

100 Years

Of Experience

Leading Provider

Of Polymer Sealing Solutions

FLUOROLON PEEK 3012

DOWNLOAD MATERIAL SPEC SHEET

Fluorolon 3012 is a proprietary bearing grade PEEK resin, reinforced with carbon fibers, internally lubricated with synthetic lubricates to enhance performance. Tribological tests have shown friction and wear rates much lower that other polymer bearings composites available in the marketplace. An excellent material for a wide variety of demanding applications where chemical, thermal, wear and low friction high load service is required.

APPLICATIONS:

Bearings, Bushings, Seats,

Property
Specified
Units
Method
Tensile Strength
11,000
psi
ASTM D638
Elongation
2
%
ASTM D638
Tensile Modulus
850,000
psi
ASTM D638
Compressive Strength
26,500
psi
ASTM D695
Flexural Strength
27,500
psi
ASMT D790
Flexural Modulus
1,100,000
psi
ASTM D790
Notched Impact
.7
ft/lb/in
ASTM D256
Hardness
85
Shore-D
ASTM D785
Coefficient of Friction
.21
Dynamic
PTM 55007
Service Temperature
500
(F)
Thermal Expansion
1.7 x 10` 5th
in/in/f
ASTM E 838
Wear Factor “K” x 10 .-10th
100
In.3-min/ft.lbshr h/llblb.hr/hr
ATM-66010
Specific Gravity
1.44
ASTM D792
Water Absorption
.05
24 hours-%
ASTM D570
Dielectric
kv/cm
ASTM D149
Flammability
V-0
UL-94
Resistance to oils, fuels, solvents
excellent

This information corresponds to our current information on the subject. It is offered solely to provide suggestions for your own experimentation. It is not intended, however, to substitute for any testing you may need to conduct to determine for yourself the suitability of our products for your particular purposes. Since we cannot anticipate all variations in actual end-use conditions, Advanced EMC Technologies makes no warranties and assumes no liability in connection with any use of this information.

Top
Request a QuoteRequest a Quote Today!
Contact Us