FLUOROLON POLYIMIDE TP2-372

Share
by admin

Fluorolon 4002 is a polyimide material reinforced with 15% graphite. This unique combination provides outstanding mechanical strength and wear resistance. The polymer can run continuous at 600 F with excursions short term intermittent to 900 F. This exceptional bearing material is suited for high load high PV applications. Also good in dry gas or vacuum environments.

APPLICATIONS:

Critical applications wear high temperature and high load bearings are required. This material has excellent chemical resistance .

Property
Specified
Units
Method
Tensile Strength
9500
psi
ASTM D638
Flexural Modulus
550,000
psi
ASTM D638
Tensile Elongation
4.5
%
ASTM D638
Compressive Strength
19,300
psi
ASTM D695
Flexural Strength
16,000
psi
ASMT D790
Limiting PV
80,000
ft lbs./in2/min
EMC TM0057
Notched Impact
.8
ft/lb/in
ASTM D256
Hardness
E45
Coefficient of Friction
24
Dynamic
dry vs steel
Service Temperature Continuos
575
F
Thermal Expansion
2.7 10^5th
in/in/f
ASTM D696
Wear Factor
Specific Gravity
1.51
g/cm3
ASTM D792
Water Absorption
.19
24 hours-%
ASTM D570
Dielectric Strength .125” Thick
250
V/Mil
ASTM D149
Flammability
V-0
–
ASTM D639
Resistance to oils, fuels, solvents
excellent
–
–

This information corresponds to our current information on the subject. It is offered solely to provide suggestions for your own experimentation. It is not intended, however, to substitute for any testing you may need to conduct to determine for yourself the suitability of our products for your particular purposes. Since we cannot anticipate all variations in actual end-use conditions, Advanced EMC Technologies makes no warranties and assumes no liability in connection with any use of this information.