Fluorolon 5100H High Molecular Weight Polyethylene, is especially suited for low to medium load/medium rpm bearing applications. Specially formulated to resist 275 F in continuous service.

APPLICATIONS:

Fluorolon 5100H typical applications are as followes: bushings, bearings, mill impact plates, pulleys, sprockets, slipper pad liners, and dryer bushings. Inert to moisture.

Property
Specified
Units
Method
Tensile Strength
5,800
psi
ASTM D638
Elongation
300
%
ASTM D638
Tensile Modulus
100,000
psi
ASTM D638
Compressive Modulus
69,650
psi
ASTM D695
Flexural Strength
3,500
psi
ASMT D790
Flexural Modulus
110,000
psi
ASTM D790
Notched Impact
Non-break
ft/lb/in
ASTM D256A
Hardness
69
shore-D
ASTM D-2240
Coefficient of Friction
.12
ASTM D-1894
Service Temperature
275
F
Thermal Expansion
in/in/F
E-831
Wear Factor
120
k
K (in3/min/ft/lb/hr
Specific Gravity
.95
g/cm3
ASTM D792
Water Absorption
NIL
24hours-%
ASTM D570
Dielectric
900
KV / mm
ASTM D149
Flammability
V-2
ASTM D639
Resistance to oils, fuels, solvents
excellent

This information corresponds to our current information on the subject. It is offered solely to provide suggestions for your own experimentation. It is not intended, however, to substitute for any testing you may need to conduct to determine for yourself the suitability of our products for your particular purposes. Since we cannot anticipate all variations in actual end-use conditions, Advanced EMC Technologies makes no warranties and assumes no liability in connection with any use of this information